NearMoon Shower Arm, Extra Fixed Arm with Flange, Stainless Steel Wall-Mounted ShowerHead Arm (15 Inch, Chrome Finish)

Sturdy, the metal plating so far is holding up well, long enough permit you to stand away from the wall... Nothing much more to say. I highly recommend anyone considering this size pipe, to consider using JB Weld Water Weld epoxy putty to fill the opening in the tile/wall before installing the shower head. This will give strength and support to the fitting and reduce the stress at the threaded joint, and lessen the chance of breakage or leaks, as you will be effectively creating a hard as concrete block under the pipe that will support the weight further out away from the threaded joint.Also highly recommend using both PFFE tape and Plumbers Dope on the threaded to eliminate any leaks at the joint inside the wall.I installed mine by removing the old shower head neck, cleaning the joint from old tape, drying the joint in the wall; wrapping the new shower arm threading with PFFE tape three-four turns on both threaded ends; added a good amount of plumbers dope (liquid thread sealer) and then screwed in the new shower arm until hand tight and in the proper position. I then waited five minutes for the dope and tape to settle into the threads (being overly cautious, this wasn't needed) and then turn the water on full blast, using a flashlight to check the fitting for leaks. After seeing none, I then stopped the open shower arm with my thumb to pressurize the joint, and again checked for leaks. After seeing none two minutes into being pressurized, I turned the water off, mixed the epoxy putty (be sure to wear two layers of gloves when doing this, as you will NEVER get this stuff off of your naked skin), filled the opening in the tile and wall all around the shower arm, pushing extra putty under the shower arm itself, and then put the escutcheon over the opening, and going to bed. The epoxy needs one hour to cure, but I gave it overnight. In the morning, I screwed on the shower head until hand tight, gave it a quarter turn with a wrench further, and I was done.Rewarded myself with a very, VERY relaxing hot rain shower...

this was great for my shower. I had to add a water pressure valve since the water comes out so fast. great waterfall for a great value.

Strong and solid

Shower head to low

This shower head adapter works perfectly it extends the shower head just perfectly so that I can take a comfortable shower and relax it is very relaxing and enjoyable to take a shower with this extension onto my shower head and I suggest it for anyone that needs an extension on their head

just what i wanted easy to install love it

Places the shower head right where I wanted it. Was easy to install. Comes with some extra o-rings. One o-ring is already installed. My eyes are not so good and I was trying to install a second o-ring because I did not see the one already installed. I figured it out when the o-ring would not seat properly.

It was good price and material. I liked that it has plumbers tape with it. Works well and looks good.

Nicely built and good quality. Fast shipment. Have not installed yet, as waiting for the completion of wall panels installation.

Se ve de lujo

Es muy delgado y se abrió al instalar es muy frágil para lo debe usarse no recomendable

Facile a installer, bon produit